inżynieria: Seismic analysis

Most buildings, however, have higher modes of response, which are uniquely activated during earthquakes.

Seismic analysis is a subset of structural analysis and is the calculation of the response of a building (or nonbuilding) structure to earthquakes. It is part of the process of structural design, earthquake engineering or structural assessment and retrofit (see structural engineering) in regions where earthquakes are prevalent. As seen in the figure, a building has the potential to 'wave' back and forth during an earthquake (or even a severe wind storm). This is called the 'fundamental mode', and is the lowest frequency of building response. Most buildings, however, have higher modes of response, which are uniquely activated during earthquakes. The figure just shows the second mode, but there are higher 'shimmy' (abnormal vibration) modes. Nevertheless, the first and second modes tend to cause the most damage in most cases. The earliest provisions for seismic resistance were the requirement to design for a lateral force equal to a proportion of the building weight (applied at each floor level). This approach was adopted in the appendix of the 1927 Uniform Building Code (UBC), which was used on the west coast of the United States. It later became clear that the dynamic properties of the structure affected the loads generated during an earthquake. In the Los Angeles County Building Code of 1943 a provision to vary the load based on the number of floor levels was adopted (based o…

Kategoria: inżynieria

Rodzina: inżynieria

Jakość źródła: 65/100

Próby weryfikacji: 3

Notatka fact-checku: Fact-check 3.0-content-aware: no sufficient claim-bound corroboration after 3 healthy attempts. Scope=verify the factual claim. Required independent sources=2; stored evidence groups=1. Provider/API errors did not consume attempts. | Fact-check 4.3.2: research wznowiony bez zdejmowania HOLD. Poprzednia metoda: factcheck-300-content-aware.